Turning Point Mach4 Express Blade Stainless Steel Propeller only - EX Model. Note that a Turning Point propeller hub kit needs to be purchased separately to the propeller.

The Prop that put the “four” in Perfourmance! Turning Point’s Four Blade Hustler revolutionised the aluminum propeller market when introduced over 6 years ago. No one had ever produced an aluminium propeller with two different blade shapes for 90-300+hp applications and a state-of-the-art Swept Cleaver design for 40-150hp applications.

These props re-wrote the rules, proving that you can run a four-blade that has unprecedented holeshot, handling, and rough water stability without the top-end speed loss you experience with other manufacturers’ propellers.

The Express Mach4 series is perfect for any application that demands enhanced acceleration, cornering, and load carrying capabilities. This prop series is ideally suited for watersports, sterndrive boats, tri-toons, bay boats, and any vessel that can use a stern lift. It is the best upgrade of older stainless designs from the ’70s, ’80s, '90s, and ’00s, and will outrun most newer props, including five blade ski props.

NOTE: **Motors 200HP and above must use series 700 Hub Kits. Failure to use will void warranty.

Choosing your Turning Point propeller is a two-step process:

1. This propeller suits the motors listed below. If your motor is not listed, see other Turning Point propellers.
2. Purchase the associated Hub Installation Kit which should suit the drive shaft on your outboard.

NOTE - PROPELLER HUB KIT IS SOLD SEPARATELY. SEE TABLE BELOW. 

This propeller is compatible with the following outboard motors