This is a heavy duty Superior Engineering Brake Proportioning Valve Bracket Suitable For Toyota Prado 150, Prado 120 with a 4" inch lift.

When a lift Kit is fitted to a 4wd it is mandatory to fit a correct size proportioning bracket.

4WD's have a "Brake Bias" or proportioning valve that is fitted to the braking system, The purpose of this is to allow the correct proportion of brakes between the front and the rear brakes.

If a vehicle has a lift fitted, the Proportioning valve / Brake Bias will think that there is no load on the rear end so the brakes will not perform correctly for the vehicle and this may cause a vehicle to lose control and crash.

As a general rule you must lift the proportioning bracket / Brake Bias Bracket mounting point up the same amount as the vehicle is lifted over standard "factory" height.

So if you have a 4 inch lift you should lift your proportioning valve / Brake Bias up approx 4 inches.

Superior Engineering manufactures and sells these inexpensive Proportioning brackets to enable your brakes to perform at their peak.

It is also recommended to fit Braided brake lines if you have fitted larger tires or raised the vehicle.

The Superior Engineering Proportioning Valve Brackets / Brake Bias simply Bolt on with just a couple of spanners!

Why would you risk your safety by not fitting one of these?

NOTE: Some Prado models do not have a proportioning valve, is it recommended to check prior to ordering.